• Frequency Range 156 – 163.275MHz
• Channels INT, USA, CAN
• Channel Spacing 25 kHz
• Communication Method Simplex / semi duplex
• Antenna Impedance 50 ohm
• Antenna Helical
• Battery Type 1800 mAh Li-Ion battery pack
• Power Supply Voltage 7.4V DC
• Current Drain (nominal) TBA
• Duty Cycle (5/5/90) TBA
• Microphone Internal condenser microphone
• Operating Temperature -20° to +55°
• Size (mm) 59.5 (W) x 130 (H) x 37 (D)
• W = 59.5 (62 including protrusions)
• H = 130 (145 inc knobs)
• D = 37mm (41 including battery protrusions)
• Weight 277g with battery and aerial

Transmitter

• Power Output HIGH – 5W, LOW – 1W
• Modulation 16K0F3E
• Oscillator Method PLL
• Frequency Stability < ±0.0002% (±2PPM)
• Maximum Deviation ±5 kHz
• Audio Distortion < 5% (1 kHz 60%)
• Spurious Emission -68 [dBc]
• Hum & Noise -40 [dB]

Receiver

• Receiver Type Double Super Heterodyne type
• Sensitivity <-0.25uV (12dB SINAD)
• Frequency Stability ±0.0002%(±2PPM)
• Spurious Rejection -60 dB
• Adjacent Channel Selectivity -70 dB
• Distortion < 3% Typical
• Hum & Noise -40 dB
• Audio Output 1W
• Speaker Size 38 mm

No Videos

AIS

What is AIS?

Automatic Identification System is a ship reporting system. The majority of ships these days are required to fit an AIS transponder so that they automatically transmit data to enable other users to receive this information. Click here for a full description of the system

What are the benefits of fitting an AIS Receiver?

With an AIS receiver onboard connected to either a compatible Chart Plotter or PC Charting program you can view other vessels within VHF radio range and establish such information as name, current position, course and speed. This information can then be used to assist safe navigation.

Why are all your COMAR Receivers Dual Channel Parallel?

To ensure that you receive the most up to date information quickly. Single channel or multiplex receivers will only on average receive half the number of transmissions from other vessels so not giving you a true position of their current location.

What is involved in installing an AIS Receiver?

The AIS signals operate in the VHF marine so the receiver will either need its own VHF Antenna installed, or you can use the Comar ASR 100 antenna splitter that allows you to share your existing VHF Radio antenna with the AIS Receiver. The data output from the Receiver then needs to be connected to a Chart Plotter via the NMEA cables, or to a PC by the Serial or USB connections.

What NMEA data is sent?

All our receivers output the NMEA message type VDM. By default this is sent at the speed of 38400 baud so your Chart Plotter or PC program must be configured to receive the data at this speed. On some of our receivers you can change the output to 4800 baud.

What range will I receive information from?

AIS reception will be similar to your existing VHF radio reception, typically a minimum of 20 miles in open waters. It has the same characteristics as normal VHF regard its “line of sight” therefore the higher that you place the antenna the larger the range.

Why do the ships names take longer to be displayed?

Information is sent in different message types, the basic information of MMSI, position, course and speed are sent frequently so this information shows first. The name of the vessel, type of vessel, destination etc are sent less frequently so this information takes longer to show on your display.